curtain rod holder
Description
Replacement For Bad/Useless Curtain Rod Holders. ===================================== This One Has A Hole All The Way Through For Easy Access To The Screw For Mounting And A Locking Piece That Goes Over The Rod To Hold It In Place. Made For 11Mm Diameter Curtain Rod, The Hole Is Actually 12Mm. Anything Below That Should Work Too. The *_Lock.Stl Parts Might Need To Be Scaled Depending On The Dimensional Accuracy Of Your Printer. They Work As Is On Mine. 3 (+1) Versions: ---------------------- ### Round To Be Printed Standing On The Flat Bottom (Top When Hanging) Curtain_Rod_Holder.Stl Curtain_Rod_Lock.Stl Same But With Builtin Support, After Printing, Hit It With The Pointy End Of A Hammer On The Support Piece In The Direction It Can Slide Out. Should Come Loose And Leave A Nice Surface. (There Is A 0.2Mm Gap Between The Support Piece And The Rest. Your Results May Vary Depending On Printer And Filament.) Curtain_Rod_Holder_Builtin_Support.Stl ### Version 2 Is Square: To Be Printed On The Back And No Supports Should Be Needed. Curtain_Rod_Holder_V2.Stl Curtain_Rod_Lock_V2.Stl ### Version 3 Is Almost Round, Just With A Flat Backside To Be Able To Print It Laying Down As Not To Need Supports. Curtain_Rod_Holder_V3.Stl Curtain_Rod_Lock_V3.Stl I Printed Mine In Pla On A Prusa Mk2S Assembly: If You Need Instructions, This Is Not A Job For You :P
Statistics
Likes
15
Downloads
0