Lid (Dust Cover) for CR-10 Nozzle Holder

Description

This Is A Lid Designed To Be Used With The Nifty Nozzle Holder By Frodotus (Https://Www.Thingiverse.Com/Thing:2760208 ). It Fits Over His Nozzle Holder To Protect The Nozzles From Dust. It'S Held In Place Only By The Friction From The Tabs, So You Can Easily Remove It With One Hand. The Edge Profile Is The Inverse Of The Fillet On The Nozzle Holder To Make The Seal A Little More Airtight. Wall And Top Thickness Is 1Mm. No Supports Are Required. My Cr-10 Mini Printed It In Just Under 30 Minutes With A 0.4Mm Nozzle. It'Ll Print Even Faster With Bigger Nozzles. Step And F3D Files Attached In Case You Want To Make Any Modifications. N.B. Two Of The Tabs Are Shorter Than The Rest. These Are Intended To Fit In The Slot (On The Side That Fits Into Your Printer). If The Lid Can'T Fit Because The Tabs Seem To Be Too Long, Just Turn It 180 Degrees And It Should Fit.

Statistics

Category

Tags