Blade 300X Landing Gear and Skids
Description
I Recently Had A Crash That Snapped My Landing Gear Right By A Screw. I Was Able To Plastic Weld It, But I Wanted New Gear. These Are About The Same Size And Angle As The Original Landing Gear, Except I Went Big Where The Skids Go Through So They Would Stick To The Bed Easier. I Used Green Because That Is What Was On My Printer At The Time And I Didn'T Expect The Prototype To Work The First Time Out. I Have Gotten Pretty Good At Flying And Put Very Little Stress On My Landing Gear, So These Should Last Me A While If I Can Keep From Crashing. These Are Pretty Sturdy And Should Be Able To Take A Decent Hit Like The Original Gear. The Rear End If The Skids Are Really Jammed In The Gear And I Couldn'T Get Them Out. That Is Why They Do Not Go All The Way Through. I Left Them As Is Because They Were Sturdy Enough. I Made The Tail Fin Too. That Is Available At Http://Www.Thingiverse.Com/Make:78454. My Pla Is Makergeeks Ultra Pla At Http://Makergeeks.Com/Ulplafi.Html.
Statistics
Likes
19
Downloads
0