VSR-10 hopup concave nub
Description
Made For My Jg Bar-10. The Dreaded Right Hook Hop On Anything Heavier Than .2G Struck! Then The Stock Arm Only Being Able To Hop .28G Effectively. Serves As A Self-Shimming Nub, Lifting Heavier Bb'S With Less Fps Loss. Compared To A Stock Hu That Is. Installation: 1. Turn The Stock Bucking Inside Out 2. Cut Off The Stock Rubber Bucking 'Nub' And Gently Sand/File The Inside Bucking. 3. Cut/File The 2 Prongs On Stock Hop Arm Flush And Even As You Can 4. Glue This Nub Exactly Where The Center Of The 2 Teeth/Prongs Were With Super Glue. 5. Allow To Dry (Duh) And Test Fit If Done Correctly You Can Still Hop .2G At Say 15% Settings. Hop .3G At 40% Settings. Beyond That Is A Mystery To Me. 100% Hop I Can Force A Jam. Im Only Pushing 400Fps Currently. @ 65% Hop My .3G Are Going Into Space. Hop Setting To 0% Bbs May Roll Out The Front. The Dimensions Of This Nub Make It 'Fitted' Limiting (If Any) Side To Side Play. Therefore Not Causing Bb'S To Hook Left And Right. The Length Of This Is Also Quite Extended For A Longer Contact Patch. Any Longer And This Nub Might Cause An Air Leak To The Front Of The Bucking. Let Me Know Your Results, Bad And Good.
Statistics
Likes
19
Downloads
0