Dual Extruder Prusa i3 Titan Mount
Description
I Essentially Imported The Original Version Into Onshape And Elongated It. I Made Sure To Leave Ample Room To Maneuver A Hex Key Into The Whole Thing So It Wouldn'T Be Overly Frustrating, But It'S Still Going To Be A Little Frustrating To Assemble To Be Honest. This Assumes You Are Going To Use A Mirrored Titan Extruder For The Right Side. I Didn'T Design This With Support For The Titan Aero In Mind, But It Might Work. No Guarantees There. I Put A Hole In The Mirrored Fan Holder Since The Fan Intake Will Have To Face Inwards On The Mirrored (Right) Side. I Don'T Plan On Actually Printing This Myself Until Much Later On, And It Might Be Obnoxiously Long On A Prusa I3 And Take Up Too Much Room. But That'S Something You Have To Be Prepared For When Using This Approach To Dual Extrusion. I Did Not Add Any Mounting Brackets For Sensor Mounts Since I Am Not Familiar With Using Sensors For Bed Leveling.
Statistics
Likes
11
Downloads
0