SUP Lamp
Description
This Is A Lamp Based On The Design Of A Real Sup-Board. If You Only Want To Have The Board Itself You Need To Print Sup, Sup_Fin And Sup_Plug. If You Want To Use It As A Lamp You Need Everything But The Plug Used To Seal The End. Note The Height Of Approximate 33Cm, Which Is Too Much For Most Small Printers. I Used M3X6Mm Screws To Screw In The Bottom Plate Und Used A Cheap 5V Led-Stripe To Illuminate The Board From Below. Look At Https://Www.Thingiverse.Com/Thing:2965219 For A Paddle. Check Out Https://Www.Thingiverse.Com/Thing:2860317 For A Small Keychain Version. Feel Free To Ask For Further Informations Should Any Questions Arise.
Statistics
Likes
35
Downloads
0