Prusa Door and Spool Holder - Usability Remix
Description
This Is A Few Remixed Parts From The Semi-Official Prusa Mk3 Enclosure Project (Https://Goo.Gl/Ssr5Fm). I Found The Spool Holder Bearings Less Than Ideal, And Not Smooth, Occasionally Causing My Spools To Fall Out Sometimes. I Remixed The Spool Holder Bearings To Allow Adding A Standard 8Mm X 22Mm X 7Mm Bearing, While Using The Same Base. I Also Found That The Magnets Are Hard To Come By For The Handles, So I Remixed The Handles To Allow The Use Of The Same Magnets Used In The Extruder Visualizer Project (Https://Goo.Gl/Mr3Cdc), Because I Had Extras. You'Ll Need Some: -8Mm X 22Mm X 7Mm Bearings - Https://Goo.Gl/Cpnhxi -Regular Superglue To Hold The Bearing Half'S Together. (I Made Them Half'S, To Make It Easier To Align Them Perfectly). -8X3Mm Round Magnets (The Same Ones Used In The Visulizer Project Https://Goo.Gl/Lkswgj)
Statistics
Likes
14
Downloads
0