Prusa MK3 Tilted Fan Adapter
Description
This Is Based On [2076234](Https://Www.Thingiverse.Com/Thing:2076234) But Designed From Scratch. The Fan Is Tilted Up And Forward 45°. The Benefits Of This, According To The Author Of The Mk2 Fan Adapter, Are: * Fan Is Pumping Cooler Air (Instead Of Warm From The Bed) As It'S Tilted Upwards. * Less Intake Turbulence (No Warping On This Side Of The Bed) You'Ll Need To Get More Slack To The Noctua Fan Wires. I Had To Clip The Zip Ties Behind The Extruder Body And, Starting At The Einsy Board, Pull An Extra 3" Or So Through The Wire Wrap Until I Was Able To Pull The Fan Out Far Enough To Reach The Front Of This Mount. Then Just Tuck The Wires Over The Top Of Mount And Reinstall The Zip Ties When Done. The Fan Cover From The Link Above Will Fit, If You Want One. Mounting Screws: * (4) M3 X 8Mm (To Mount To Extruder Body) * (4) M3 X 12Mm (To Mount Fan)
Statistics
Likes
29
Downloads
0