Dachshund Shelled
Description
This Is A Hollowed Out Version Of The Original Dachshund, With A 2Mm Shell Thickness. It Has A Drain Hole Cut Into The Bottom Rear Hindquarters (Where The Dog'S Bum Would Go), Strategically Obscured By The Tail. It Also Has Small Nostril Tubes To Act As Vents For Draining (With Turns Near The End To Help Hide Them, So You Don'T See Straight Into The Innards Of The Model When Peering Up Its Nose). The Tail Is Slightly Lengthened. Prints Great On My Form 1+ With Minimal Support Contacts. Uses 6.7Ml Of Resin, Or 10.5Ml Including The Support Structure.
Statistics
Likes
17
Downloads
0