ECX circuit servo saver
Description
Noticed The Steering Was Getting Very Sloppy On My Ecx Circuit Stadium Truck So I Quickly Knocked Up And Printed A New Servo Saver Steering Block. Steering Is Now Spot On! I'D Probably Say Pla May Be A Bit Stiff For This Job And Liable To Snap If You Smack The Front Wheels Hard Enough Or Not Provide Enough Give To Save The Servo.......But I Could Be Wrong! Printed In Abs At 100% Infill, No Supports Needed, Only Takes A Few Minutes To Print And Slower Is Better. May Need Some Slight Adjustment With A Round/Half Round Needle File To Get The Best Fit. If It'S Way Too Tight Increase X&Y Axis By A Couple Of % To Get You In The Ball Park.
Statistics
Likes
9
Downloads
0