My Micro-Quadcopters

See the video:https://youtu.be/NNmSKSIQRBE

Three designs of a micro quadrocopter for garden und park racing and learning to fly.

The frame size is (rotor to rotor) 68 mm x 68 mm and 78 mm x 68 mm. The version 78x68 is a little bit easier to fly for beginners, but some bit heavier.

I designed these frames because I was tired of buying carbon frames, defective cameras or antennas and other spare parts after every crash. Even though they are a little bit less lightweight than carbon frames, the quads are flying good and the frame is easy to print and replaceable.

The L3GO-Version is for my little daughters. They fly without camera but with their favorite characters Olivia and Emma from Lego Friends as pilot and passenger.:-)

Some advantages to some other designs I tried:

- The camera has a housing and is more protected in case of a crash.

- The frame top protects receiver and flight controller

- The flight controller is held in place on the frame by small clips and has not to be glued.

- Antenna guards lead the wires downwards and help to protect the RX-antenna against getting catched in the rotors.

- The LED-Strip is fixed with screws (no lost rubber bands anymore).

- The LiPo can be mounted on the bottom or the top.

- Enough space for a 9 mm extra load beeper.

The assembly is quite easy. See the pictures and video description.

For assembly I designed a tool to press the motors in the frame. They must fit very tight otherwise they get loose. Put the motor in the tool and then press it in the frame with connectors downwards. Take care not to cut the cables.

What you need:

4 x brushed micro motors 8.5 mm x 20 mm
1 x flight controller Eachine (with the receiver of your choice or without tx)
optional 1 x receiver separate
4 x props
1 x beeper 5 V
1 x AIO-Camera with VTX
1 x NEOpixel-Strip (with 4 LEDs)
4 x nylon bolts and nuts M3x20
2 x nylon bolts and nuts M3x5
5 x LiPo 1S 600 mAh

All parts printed in PETG with 80 % infill without support.

Found 10 3D-models for “quadrokopter” across many websites

HP-V1 Quadrocopter

NB4 Quadcopter Concept

Quadrocopter motor-mount for 15mm aluminium square tubing

KoZZ-250

DJi Mavic Pro Big parts set :-)

Landebein für Quadrokopter

Holder for TBS Unify Pigtail on AMAX Inno Freestyle Frame

BLADE NANO QX FPV CASE (repaired lid)

Micro Quadrocopter

Tyro129 Body Kit