Instructions: 1 Firstly Open The Arduino Id, Open The Porogram File And Write On The Arduino Ide The Pins You Are Gonna Use In The Variables Called Pines. (Lines 80-110) In The Program. 2 You Have To Calibrate The Servomotors Puting The Angle That Correspond With The Angle That Makes The Robot Be Straight With The Varaiables Vca, Vcb, Vcd And Vcd, Try To Change The Values; It Must To Be Around 90 Degrees. (Lines 130-135) In The Program. 3 Select Your Tipe Of Led (Negative Or Positive Common)In (Line 139) In The Program If It Is Negative Put 1 Or 2 If It Is Positive. 4 If You Used The Chinese Arduino Nano, You Have To Instal Its Drivers. 5 Then Select In Tools: The Board (Arduino Nano), The Processor (Atmega328) And The Port, If You Don'T Know Which Port You Have To Use, Open The Administrator Of Decives In Control Panel And Search The Arduino. An Example Is (Com3). 6 Now You Are Ready To Upload The Progran, Remember To Conect The Board And Clic At Upload Or Ctrl+U. * If You Have Any Question Ask Me On: Http://Www.Thingiverse.Com/Thing:2083489/#Comments Or By Email Fernandezaginer@Gmail.Com . Building Materials: -Pieces 3D -Arduino Nano Buy In Internet Aroud 3$ -Placa De Expansion Buy In Internet Around 1$ -4 Servos Sg90 Buy In Internet Around 6$ -Bluetooth Module Hc-06 Buy In Internet Aroud 3$ -Hc-Sr04 Buy In Internet Around 1$ -Buzzer Buy In Internet Around 1$ (You Have To Buy 5, Because There Isn'T Any Page That Only Sells 1) -Led Rgb Buy In Internet Around 1$ (You Have To Buy 10, Because There Isn'T Any Page That Only Sells 1) Video: Video This Thing Has Been Remixed With Tinkercad By Andrés Fernández Muñoz In Spain At May 2017

Found 11 3D-models for “zowi arduino” across many websites

Nuevo Chasis Zowi Arduino UNO & Funduino

Zowimanoid template

MicroRaider

ZowiPO

Mintxo

MiniZowi

Otto Remix by Fernandezaginer

Plasteac, the robotic dancing teapot

Bolo DIY

OttoDIY-MXR

Zowi DIY build your own robot with Arduino